Very Early Spring 2014 - Tapping the Sugar Maples!
The first year of Pure Maple Syrup-Making at Primal Woods
Getting in the way-back machine for a look at our first year of making Pure Maple Syrup. This was first published on primalwoods.com.
Yes indeed, spring has sprung! And not only because we set our clocks ahead, but more importantly because sap is flowing from our maple trees which is a more certain sign of spring! We are very excited, especially since maple syrup will be one of the very first "products" of the homestead. I am convinced that it will be well worth the work involved in its production.
Maple tree sap flows when daytime temperatures exceed freezing, 32 deg F, and nighttime temperatures dip below the freezing mark. The temperatures above freezing create a "positive pressure" within the tree, forcing sap out of the tap, while temperatures below freezing create a "negative pressure" within the tree, causing more sap to be pulled up from the roots and into the sap wood. [1] The optimum variation is said to be a high of 40 deg F and a low of 20 deg F; we tapped Sunday morning at about 9 a.m., after an overnight low of 17 deg F and leading to a daytime high of 42 deg F, and sap was flowing by noon the same day!
In addition to the freeze-thaw cycle, maple trees are an obvious requirement for the production of maple syrup or sugar. The two most productive types of maples are the appropriately named "sugar maple," and the black maple, followed by the red maple and the silver maple. The sugar content of sugar and black maple sap is typically in the range of 2.0-5.0%. [2] I identified seven sugar maples last summer using leaves and fruits (samara), and a further six this past Saturday; for the winter identification, I relied heavily on Michigan Trees, Revised and Updated: A Guide to the Trees of the Great Lakes Region, and specifically on the presence of opposite twigs and visible (dried) male flowers. [3] In some cases, I needed my binoculars to see the male flowers far up in the canopy.
Geri and I wanted to use traditional methods for collection of the maple sap. I did not want unsightly plastic tubing running here and there, and worse yet vacuum pumps, which from my point of view make the trees look like seriously ill patients on life support. We acknowledge that the view might look considerably different were we trying to maximize income from the trees. For sugaring equipment I purchased two starter kits from Tap My Trees, which came with the guide "Maple Sugaring at Home," [4] by Joe McHale. In hindsight I probably spent more than necessary, though I am also more than happy with the kits and the guide from Tap My Trees. When we decided that we wanted to tap more than six trees, we bought additional used equipment from a local commercial "sugarer," Don Dodd of Dodd's Sugar Shack in Niles, MI, at a fraction of the price; of course that is knowing what I know now, not what I knew a few weeks ago when I bought the kits. The general guidance I am following is to tap no tree less than 12 inches in diameter (approximately 38 inches around), tap on the south side of the tree to maximize exposure to the sun, and to tap below a larger branch or above a larger root formation. Do avoid previous tap holes and other obvious injuries to the tree. Also, tap the tree at a height that makes collecting the sap convenient, as production is not impacted by tapping higher or lower on the trunk. The necessary equipment is a spile (also known as a tap, or a spout), a hook to hold the bucket, the bucket, and a bucket lid to prevent snow, rain and other contaminants from falling into the bucket. The tools required are a 7/16 inch drill bit, a drill, and a hammer. To tap the tree:
1) Drill the tap hole 2 -3 inches deep into the sap wood, at a slight upward angle to allow the sap to flow downward from the spile into the bucket; the wood chips from the hole should be very lightly colored to white, representative of healthy sap wood
2) Clear the tap hole of wood chips
3) Hammer in the spile (with hook attached) gently but firmly, the spile needs only to support the weight of the bucket and too much force can split the bark
3) Hang the bucket from the hook
4) Attach the lid over the bucket
5) Be amazed at nature's abundance!
Our trees started flowing within a few hours of tapping, quickly bringing on the next "problem," which is "what do I do with all of this sap?" By early the morning after, just 18 hours after we had tapped the trees, we had collected a total of just over 6 gallons of sap from 12 trees! Since it takes 43 gallons of sap to make 1 gallon of syrup (assuming the sap is 2% sugar), it takes large amounts of sap to make very modest amounts of syrup. If the twelve trees continue to flow as they did the first 18 hours, they will generate 24 gallons of sap every three days. Sap will "sour," making it unusable in the making of maple syrup, if it is allowed to ferment before processing. To avoid warming and fermentation of the sap we are transferring the sap from the 2-gallon aluminum collection buckets on the tree, to 5-gallon food grade buckets, which we then store in shade on the north side of our garage, with snow piled up to the lid and completely around each bucket. We may also freeze 5-gallon buckets of sap in a chest freezer to await processing. We have several of the 5-gallon food grade plastic buckets, and if that is not enough, 32-gallon food grade plastic trash barrels with lids will be used, which we will surround with snow in the same manner as with the 5-gallon buckets if necessary. Even so, we will taste each source of sap before adding its contents to the evaporator, as a small amount of soured sap can spoil a large amount of the precious syrup.
We expect to process our first batch of sap into maple syrup within two weeks. I will post our experience with the evaporation process, and hopefully the results of our taste tests!
Your comments and criticisms, your inputs and acknowledgments, are welcomed and will help me to improve my posts. Please "follow" the blog.
-- John, 10 March 2014
[1] "Sap Flow," Cornell Sugar Maple Research & Extension Program, Web. Retrieved 10 March 2014.
[2] Maple syrup. n.d. In Wikipedia Retrieved 10 March 2014, from http://en.wikipedia.org/wiki/Maple_syrup
[3] Barnes, Burton V., and Warren H. Wagner, Jr. Michigan Trees, Revised and Updated: A Guide to the Trees of the Great Lakes Region. Ann Arbor: University of Michigan, 2004. Print.
[4] McHale, Joe, Maple Sugaring at Home, U.S.A.:Reine Publishing Group, LLC, 2010. Print.